The text on this page is partially covered up. The answer to review question number two should now be true (starting with the 2017 edition of Autodesk Revit). The image on the bottom of this page should be replaced with this image. The correct values for width and height should be 9' 6" as shown in the image below. Step 24 should read: Select the outer railing, Handrail Only, and set the Offset from Path to -0’-2” in the Properties Palette.įigure 8-5.8 shows the incorrect values listed. Step 23 should read: Select the inner railing, Guardrail – Pipe, and set the Offset from Path to -0’-1” in the Properties Palette. On the Options Bar, set the Location Line to Exterior Support: Right and Actual Run Width to 3'-4", (Figure 7-7.2). Notice the more elaborate newel post family selected as a starting post. In this residential-type application there are two balusters per tread. Please refer to the image below in place of Figure 6-3.9 on page 6-32.Īnother variation on baluster placement is to place them per tread as shown in the example below Figure 7-4.16. The stairs are now added in chapter 7 for the 2017 update.
Ignore all references to stairs in this chapter. To accommodate this we have made these files available as a download with the rest of the book's downloads. This book makes use of files that were previously available on but have since been removed.
0 kommentar(er)
